Licensed C-10 Electrician — Los Angeles & Riverside
Lighting & Fixture Installation
in Los Angeles & Riverside
Recessed lighting, chandeliers, ceiling fans, exterior lighting, and landscape lighting for homes and commercial properties — installed clean and wired to code.
Installed clean. Wired correctly. Built to code.
Licensed & Insured • 25+ Years Experience • Free Estimates
What We Install
Lighting & Fixture Types
Residential and commercial lighting installation across Los Angeles and Riverside County. All work is wired correctly and completed to current code.
Recessed Lighting
Can lights for kitchens, living rooms, hallways, and bathrooms. Properly spaced layout, correct circuit sizing, and trim that fits your ceiling type.
Chandeliers & Pendants
Decorative fixtures installed with proper structural support, correct junction box, and clean wiring. No fixtures drooping or burning through junction box limits.
Ceiling Fans
Fan and light combo units installed with fan-rated junction boxes, correct wire gauges, and switch or remote controls wired to your preference.
Exterior & Security Lighting
Porch lights, wall sconces, floodlights, and motion sensors installed with weatherproof boxes and GFCI protection where required.
Landscape Lighting
Low-voltage path lights, uplighting, and accent lighting for driveways, gardens, and facades. Transformer installation and circuit routing included.
Switches & Dimmers
Dimmer switches, 3-way switch wiring, smart switch installation, and switch replacements — rated correctly for the fixture load and wiring configuration.
What We Do
What's Included in a Lighting Install
Every lighting job starts with understanding what you're trying to achieve and whether your existing wiring and circuit capacity support it. We don't just swap fixtures — we make sure the installation is right before the fixture goes in.
Every lighting installation includes:
- Circuit capacity check before installation
- Proper junction box — fan-rated where required
- Correct wire gauge for fixture amperage
- GFCI protection for wet or outdoor locations
- Switch wiring — standard, 3-way, or dimmer
- Trim-out and fixture testing before we leave
- Cleanup — no drywall dust or wire debris left behind
Design & Code
Layout Guidance & Code-Compliant Wiring
Lighting layout affects how a room feels, not just how bright it is. Recessed cans spaced too far apart leave dark corners. Fixtures on the wrong circuit trip breakers when multiple lights run at once. We help you avoid those problems from the start.
All lighting work meets current NEC and California electrical code. Bathroom and outdoor fixtures require GFCI protection. Dimmer-controlled circuits require compatible fixtures — we verify compatibility before installation.
We help you pick what works — then install it correctly.
Licensed C-10 Electrical Contractor
Sigma C&S Electric holds a California C-10 contractor license, is bonded and insured, and completes all lighting installations to code across Los Angeles and Riverside.
Related Service
Flickering lights or wiring issues?
Lighting problems aren't always about the fixture. Loose connections, faulty switches, and circuit faults are diagnosed and repaired before any new fixture goes in.
Related Service
Adding circuits for new lighting?
New recessed lighting layouts often require additional circuits. If your panel is full, we upgrade it before any new lighting goes in — no guesswork on capacity.
Get a Free Lighting Installation Estimate Today
Serving Los Angeles and Riverside — residential and commercial. We'll evaluate the work, plan the layout, and give you a clear scope before any installation begins.
Licensed • Code-Compliant • Free Estimates